Create a New Vertex

Spike

Be careful not to touch the exposed end of the syringe.

There's a spike at 33.

SSA, the angle was acute. This is an acute angle right over here. This is an acute angle right over here.

Place the needle firmly on the tip of the syringe (4).

There was the matter of that tip on the

So an acute angle will look something like that.

Insert nozzle of syringe into opening of white stopper.

Take care not to touch the end of the transfer needle.

Place the needle firmly on the tip of the syringe (4).

There is another spike visible at 22.

Ensure that the tip of the needle is in the solution.

So in this situation right over here, our angle, the angle in our

Do not touch the syringe tip or the inside of the cap.

Obtuse, I kind of imagine something that's kind of lumbering and large, so that's how I remember it, or you can say it's not acute, it's not nice and small and pointy, so that's one way to think about it.

A drop of insulin should appear at the needle tip.

You should see a stream of insulin come out of the tip of the needle.

You should see either a drop or a stream of insulin come out of the tip of the needle.

After each dose, the tip of the syringe should be wiped and the bottle cap screwed back on tightly.

5 Take the 21 gauge needle out of its wrapping and place it firmly onto the tip (nozzle) of the syringe.

Pull down your eyelid with a clean finger, until there is a pocket between the eyelid and your eye.

Use the mirror if it helps. Don t touch your eye or eyelid, surrounding areas or other surfaces with the dropper.

Your doctor or nurse will show

The drop will go in here (picture 1). Bring the bottle tip close to the eye.

The tip of the tube should not come into contact with the wound or any other surface.

Administer the dose into the mouth by placing the tip of the syringe against the inside of the cheek.

Pull shield straight off needle to avoid damaging needle point.

Put the syringe into your mouth, placing the tip of the syringe against the inside of your cheek.

Remove the protective cover from the syringe tip by breaking the white cap along the perforation.

Remove the protective rubber cover from the syringe tip by breaking the white cap along the perforation.

Clear the fluid from the dispensing tip by holding tube vertically and tapping the twist off cap.

In this case we are checking a turning insert with its tip in the number 2 direction

Before inserting the tip of the dispenser into bottle adapter, push the plunger completely down toward the tip of the dispenser.

Remove the syringe from the needle leaving the needle in the vial without touching the tip of the syringe.